受控状态：
技术文件
L171 液 晶 显 示 器 检 验 规 范
L171 Liquid Crystal Display Acceptance Criteria
1.0适用范围(Scope):
显示器的技术指标和判定标准。

适用于L171系列液晶显示器。

(The criteria specified L171 series liquid crystal display's specification and acceptance standard. It is suited for L171 series Liquid Crystal Display.)
2.0 检验标准(Acceptance Standard)：
国标GB2828-87抽样方案的Ⅱ级检查水平抽检。

AQL ：Cr----0，Ma----0.65，Mi----2.5(GB 2828-87 Sampling plan of Level II Inspection .AQL:CR:0;Ma:0.65;Mi:2.5).
3.0 检测附注(NOTES FOR INSPECTION)
检验时按此规范进行测试检验，若规范未含盖部分，请参照北泰电子有限公司工程规格。

（Inspection will be performed according to this criteria shall there any item(s) not been covered by this criteria Will refer to BIG TIDE Electronics Co., Ltd. Engineering Specification ）
5.1 目测距离50公分以上，测试环境亮度在500-1000 LUX ，室温(Veining distance is at least 50CM.environmental brightness is in 500-1000LUX,Room temperature.)。

5.2 客户无法接受但又无明确规格的缺点也为不良(That UN definite specification but customer can ’t accept is defect)。

5.3工程不稳或材料不良产生大量不良而制定限度样品，必须订定期限，未订定期限一律以半个月为限，半
个月后限度样品取消。

(The sample of engineering or material defect must be have a term. Or the term all be half a month. After the term, the sample is useless.) 5.4 冷机测试定义：机器关机半小时以上，开机两分钟之后进行测试；(Definition of clod state test:
Turn power off for at least half an hour. And turn on power for 2 minutes. To begin inspection.)
热机测试定义：开机30分钟后进行测试。

(Definition of warm state test: inspection after
turn on power 30 minutes.) 5.5 除特殊规定外，检验项目均在热机状态，1280×1024/75Hz 方式测试。

(Inspection item are in warm
state unless otherwise demand. Test state: 1280*1024/75Hz,mode.) 6.0判定标准:(Acceptance standard)
6.1电性能的检验方法,项目及规格:(electrical characteristics and specification.) 6.2 Panel 及外观检验以<<成品外观检验规范>>为准：
Panel and visual inspection a cording to <<product visual inspection criteria >>。