温度传感器：1套
Temperature sensor:one (1) set
2.4绞制螺栓
Reamer bolt
1套
One set
1
2.5艉管后轴承
Stern tube after bearing
油润滑白金轴承
Oil-lubricating, white metal bearing
1
温度传感器：2套
Stern tube after seal
型式：希普莱克斯带防渔网装置
Type:Simplex with rope protector
1
密封环：4道Viton
Rings:Four (4) Viton
直径：~467mm
Diameter:~467mm
磨损测量仪：1套
Wear down gauge:One set
Temperature sensor:two (2) sets
直径：~465mm
Diameter:~465mm
长度：~950 mm
Length:~950 mm
2.6艉管前轴承
Stern tube fore bearing
油润滑白金轴承
Oil-lubricating, white metal bearing
清洁系数85%
One (1) set of Jacket water pre-heater
Cleaning factor 85%
1
根据厂家标准
As per Maker’s
1台淡水冷却器
清洁系数85%
One (1) set of fresh water cooler
Cleaning factor 85%
Emergency diesel generator set
1
按照订货协议书。
Acc. to order agreement
6.1柴油机
Diesel engine
型式：四冲程直列带风冷散热器
Type: 4-stroke, in-line with cooling fan
1
缸数：-
No. of cylinder:-
Thickness：30(0/+20) mm
5
主柴油发电机组
Main diesel generator set
3
按照订货协议书
Acc. to order agreement.
5.1柴油机
Diesel engine
型式:直列,水冷,涡轮增压
Model: In-line, water cooling, T/C
Cooling method:Central FWcooling system
起动方式:压缩空气起动3.0 MPa
Starting method: Compress air starting3.0 MPa
安装方式:环氧树脂浇注
Installation: EpoxyResinChock
调速器:电子式
Governor: Electric type
1
直径：~467mm
Diameter:~467mm
长度：~400mm
Length:~400mm
2.7艉管前密封
Stern tube fore seal
型式：希普莱克斯
Type:Simplex
1
密封环：2道NBR
Rings:two (2)NBR
直径：~465mm
Diameter:~465mm
2.8艉管后密封
2.1中间轴
Intermediate shaft
两端联接法兰
Integrate flange couplings on both ends
1
锻钢/Forged steel
抗拉强度/Tensile strength:
600 N/mm2
长度：~8680 mm
Length:~8680 mm
直径：~375mm
Fuel oil consumption:
SMCR171.0 g/kWh+5%
CSR167 g/kWh+5%
基于燃油热值427000kcal/kg, ISO工况,满足IMO NOx排放要求,燃油380cSt/50°C
Based on lower calorific value of 42,700 kJ/kg at ISO condition and fulfilling the IMO NOx emission limitation, fuel oil380cSt at50°C
页数PAGE
1/58
BUILDER
1
主机
Main engine
6RTA48T-B
型式：二冲程、单作用、十字头、可逆转、废气涡轮增压船用柴油机，带电动辅助鼓风机
Model: 2 cycle, single acting, cross head, direct reversible type marine diesel engine will turbo-charged and electric auxiliary blowers
1
按照订货协议书
Acc. to order agreement.
缸数:6
No. of cylinders:6
缸径×冲程:480×2000mm
Bore×Stroke:480×2000mm
输出功率:
Output:
SMCR8730 kW × 127.0 rpm
CSR7420kW × 120.3rpm
燃油消耗率：
满足水下检验要求
Comply with requirement ofBIS
2.9艉管前密封油柜
Stern tube fore seal tank
容量：~15L
Capacity: ~15L
1
根据厂家标准
As per Maker’s
2.10艉管后密封油柜
Stern tube after seal tank
Milli-volt meter:One (1) set
4
主机环氧树脂垫
Epoxy resin chock
根据主机厂推荐
According to recommendation of main engine maker
1
按照订货协议书
Acc. to order agreement.
厚度：30(0/+20) mm
容量：~15L
Capacity: ~15L
1
根据厂家标准
As per Maker’s
3
轴接地装置
Shafting grounding device
碳刷
Carbon brush
1
按照订货协议书
Acc. to order agreement.
直径：~375 mm
Diameter:~375 mm
毫伏表:1台
（设备管理）
PLAN HISTORY
日期
DATE
版本
REVISION
.
标记
MARK
说明
DESCRIPTION
设绘
DESIGNED
校核
CHKD
审定
APPRD
R
For reference
注：
本清单根据建造技术规格书整理，其它有关订货要求见建造技术规格书。
部分设备参数及配置将在设计过程中完善补充。
船级社CLASS.
3
功率：~1000 kWe
Power:~1000 kWe
转速：900 or 1200 r/min
Speed:900 or 1200 r/min
电压：450V
Voltage:450V
频率：60Hzห้องสมุดไป่ตู้
Frequency:60Hz
防护等级：IP22或IP23
Enclosure: IP22 or IP23
6
应急柴油发电机组
3
根据厂家标准
As per Maker’s
1台滑油冷却器
清洁系数85%
One (1) set of LO cooler
Cleaning factor 85%
3
根据厂家标准
As per Maker’s
5.2发电机
Alternator
型式：船用、三相
Type: Marine, three (3) phase
1台/ One (1) set
盘车机:
T/G with starter:
440V,60HZ,2.2kW
辅助鼓风机:
Aux. blower:
2台/two (2) sets
440V,60HZ,21kW
油嘴试验装置:
Fuel oil nozzle tester:
1台/ One (1) set
功率测量仪:
Power indicator:
缸径：- mm
Bore:- mm
行程：- mm
Stroke:- mm
功率：~150 kW
Power:~150 kW
转速：1800 r/min
Speed:1800 r/min
燃油耗率：- g/kW·h+5%
FO consumption:- g/kW.h+5%
基于燃油热值427000kcal/kg, ISO工况,燃油MDO
直径：~460mm
Diameter:~460mm
2.3中间轴承
Intermediate shaft bearing
直径：~380mm
Diameter:~380mm
1
自润滑淡水冷却
Self-lubricating, fresh water cooling