当前位置:
文档之家› 8D报告经典案例(划伤异常回复报告-5why)
8D报告经典案例(划伤异常回复报告-5why)
Section 1(To be filled out by Any Dept任意部门填写)
Non Conformance Description不良描述:
1.1 What发生的问题:
产品表面划伤
1.2 When发生时间:
1.3 Where发生地点:
Incoming inspection
1.4 What’s condition when the problem happened问题如何发生的:
Solutions Implementation Follow-up对策执行后续追踪
Rep Signature负责人:Title职位: Date日期:
Note: This CAR should reply to IDEX Quality Dept. within 6 working days
注:CAR须在发行日起六个工作日内返回
Supplier CAR供应商纠正措施报告
文件编号:
Requested by
提出人
Initiated Date
发出日期
Required date
要求完成日期
Receive Dept
接收部门
Receive owner接人Supplier and NO.
供应商及其代码
Finished Date
完成日期
1.Identify Root cause不良原因
1stWhy第一层为什么:
为什么产品表面划伤?
因为:(1)产品在制程中因产品相互磨擦而造成表面划伤
(2)产品在冲压时,放料时碰撞模具而造成划伤
2ndWhy第二层为什么:
(1)为什么产品在制程中会产品相互磨擦?因为作业人员未按规定在产品摆放时将产品一个个分开,而是将产品叠压在了一起
This issue found by incoming inspection
Part NO.
料号
PO NO.
PO号
Lot NO.
批号
Total Qty Received
收货总数
Sample Qty.
抽检数量
50
Defects Qty.
不良数量
3
Defect Rate
不良率
Section 2(To be filled out by Receive Owner. Supplier is the Receive Owner for External CARs流程负责人负责填写,针对材料问题,供应商是流程负责人)
4.Verification of the Effectiveness of the solution implementation对策验证有效性:
Verification Date验证日期:20XX/11/5
Section 3(To be filled out by IDEX Quality Dept.由IDEX质量部门填写)
(1)加强过程检验
(2)外观全检,制定外观允收/不允收样品
Implementation Date执行日期:20XX.10.28
3.Long Term Corrective Action长期预防措施:
(1)制作吸塑盘或其它便于作业的方式
(2)更改料的放置高度/在模具外侧增加防划伤的措施
Implementation Date执行日期:20XX/10/28
(2)为什么放料时会碰撞模具?因为料与模具的高度不适合取放料/有可能是另外原因,如料易碰模具外侧,导致划伤
3rdWhy第三层
(1)为什么工人将产品叠在一起?因为规定的方法并不方便作业
4thWhy第四层为什么:
5thWhy第五层为什么:
2.Short Term Corrective Action短期纠正措施: