Cisco CCNA 认证考试最新真题体验1. The command frame-relay map ip 10.121.16.8 102 broadcast was entered on the router. Which of the following statements is true concerning this command?A.This command should be executed from the global configuration mode.B.The IP address 10.121.16.8 is the local router port used to forward data.C.102 is the remote DLCI that will receive the information.D.The broadcast option allows packets, such as RIP updates, to be forwarded across the PVC2. While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the OSI model does the problem most likely exist?A.the session layerB.the network layerC.the data link layerD.the access layer3. In order to allow the establishment of a Telnet session with a router, which set of commands must be configured?A.router(config)# line console 0router(config-line)# enable password ciscoB.router(config)# line console 0router(config-line)# enable secret ciscorouter(config-line)# loginC.router(config)# line console 0router(config-line)# password ciscorouter(config-line)# loginD.router(config)# line vty 0router(config-line)# password cisco router(config-line)# login4. On point-to-point networks, OSPF hello packets are addressed to which address?A.127.0.0.1B.192.168.0.5C.224.0.0.5D.254.255.255.2555. What should be part of a comprehensive network security plan?A.Allow users to develop their own approach to network security.B.Physically secure network equipment from potential access by unauthorized individualsC.Encourage users to use personal information in their passwords to minimize the likelihood of passwords being forgottenD.Delay deployment of software patches and updates until their effect on end-user equipment is well known and widely reported6. During startup, the router displays the following error message:boot: cannot open "flash:" What will the router do next?A.Because of damaged flash memory, the router will fail the POST.B.It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialogC.It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM.D.It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog7. At which OSI layer is a logical path created between two host systems?A.sessionB.transportworkD.physical8. A routing protocol is required that supports:1) routing update authentication2) an addressing scheme that conserves IP addresses3) multiple vendors4) a network with over 50 routersWhich routing protocol fulfills these requirements?A.RIPv1B.RIPv2C.EIGRPD.OSPF9. When a new trunk is configured on a 2950 switch, which VLANs by default are allowed over the trunk link?A.no VLANsB.all VLANsC.only VLANs 1 - 6D.only the VLANs that are specified when creating the trunk10. Which protocol provides a method of sharing VLAN configuration information between switches?A.VTPB.STPC.ISLD.802.1QDBDCB CCDBA博主的更多文章>>CCNA第一学期《Final Examination》2009-02-27 08:58:47 标签：CCNA[推送到技术圈]1请参见图示。
下列哪组设备仅包含中间设备？A、B、D、GA、B、E、FC、D、G、IG、H、I、J2您所在的网际网络发生了路由问题。
要鉴别此错误，应该检查以下哪种类型的设备？接入点主机路由器交换机3请参见图示。
技术人员正在处理网络问题，需要验证路由器的LAN 接口。
要确认路由器接口工作正常，应该从此主机ping 哪个地址？127.0.0.1192.168.64.196192.168.254.1192.168.254.9192.168.254.2544下列哪三项陈述说明了传输层协议的特征？（选择三项）应用层协议使用TCP 端口号和UDP 端口号。
TCP 使用端口号提供可靠的IP 数据包传输。
UDP 使用窗口和确认获得可靠的数据传输。
TCP 使用窗口和定序提供可靠的数据传输。
TCP 是面向连接的协议。
UDP 是无连接协议。
5OSI 模型的哪两项功能在第2 层实现？（选择两项）物理编址编码路由介质访问控制6由于发生安全规规事件，必须更改路由器口令。
从以下配置项可获知什么信息？（选择两项。
）Router(config)#line vty 0 3Router(config-line)# password c13c0Router(config-line)#login这些配置项对远程访问指定了三条Telnet 线路。
这些配置项对远程访问指定了四条Telnet 线路。
这些配置项将控制台口令和Telnet 口令设置为"c13c0"。
因为Telnet 配置不完整，所以Telnet 访问将遭到拒绝。
允许使用"c13c0" 作为口令访问Telnet。
7请参见图示。
电缆1 和电缆 2 的两端分别按照特定的物理层要求接线。
表中按编号列出了每个网段以及网络技术人员在该网段不同网络组件之间已经安装的电缆。
根据给定的数据回答，哪些网段的电缆安装正确？（选择三项）网段1网段2网段3网段58下列哪种提示符代表适合copy running-config startup-config命令使用的模式？Switch-6J>Switch-6J#Switch-6J(config)#Switch-6J(config-if)#Switch-6J(config-line)#9请参见图示。
下列关于图中所示IP 配置的陈述，哪三项是正确的？（选择三项）分配给该计算机的地址代表私有地址。
该计算机无法在本地网络外通信。
此计算机的网络可支持126 台主机。
该计算机地址的前缀是/27。
分配给该计算机的IP 地址可在Internet 上路由。
分配给该计算机的IP 地址是广播地址。
1 0第4 层报头包含帮助数据传输的哪一类信息？服务端口号主机逻辑地址设备物理地址虚拟连接标识符1 1何时必须使用clock rate命令配置路由器串行接口？当该接口充当DTE 设备时当该接口计时器已经清除时当连接的DTE 设备关闭时当该接口充当DCE 设备时1在封装过程中，传输层添加什么标识符？2路由数据包的两个网络进行数据通信的两个应用程序分别位于通信两端的两台主机本地网络中交换帧的两个节点13请参见图示。