1 of 2
深圳理悠科技有限公司
RATINGS AND CHARACTERISTIC CURVES MB1S THRU MB10S
I(AV), AVERAGE FORWARD RECTIFIED CURRENT (A)

0.6
IF, INSTANTANEOUS FORWARD CURRENT (A)
100
Fig. 4 Typical Junction Capacitance
TJ = 25°C f = 1.0MHz
20
Cj, JUNCTION CAPACITANCE (pF)
10
10
10
TA = 25°C Single Half Sine-Wave Pulse Width = 8.3ms (JEDEC Method)
Ideal for printed circuit board Reliable low cost construction utilizing molded plastic technique High temperature soldering guaranteed: 260 /10 seconds at 5 lbs., (2.3kg) tension Small size, simple installation High surge current capability
IFSM
35
Amps
VF IR CJ R JA TJ TSTG
1.1 5.0 500 13 70 -55 to +150 -55 to +150
Volts uA uA pF /W
NOTES:1.On glass epoxy P.C.B. mounted on 0.05x0.05''(1.3x1.3mm) pads 2.On aluminum substrate P.C.B. with on area of 0.8''x0.8''(20x20mm) mounted on 0.05X0.05''(1.3X1.3mm) solder pad 3.Measured at 1.0MHz and applied reverse voltage of 4.0 volts.
10
1 .0 T J= 2 5 C
O
0 .1 20 40 60 80 100 120
PERCENT OF RATED PEAK INVERSE VOLTGE (V)
2 of 2
.008(0.20) MAX
.083(2.12) .043(1.10)
Dimensions in inches and (millimeters)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ambient temperature unless otherwise specified. Single phase half-wave 60Hz,resistive or inductive load, for capacitive load derate current by 20%. Part Number Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum average forward rectified current at TC=30 On glass-epoxy P.C.B. On aluminum substrate Peak forward surge current, 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage drop per leg at 0.4A Maximum DC reverse current TA=25 at rated DC blocking voltage TA=125 Typical junction capactiance per leg(Note3) Typical thermal resistance per leg Operating temperature range storage temperature range
1.0
Fig. 1 Output Current Derating Curve
10
Fig. 2 Typical Forward Characteristics (per leg)
1.0
0.4
0.1
0.2
0
0
40
80
120
160
0.01 0.2 0.4 0.6 0.8 1.0
TA= 25°C Pulse WidL DATA
Case: Molded plastic body Terminals: Plated leads solderable per MIL-STD-750, Method 2026 Polarity: Polarity symbols marked on case Mounting Position: Any Weight:0.008 ounce, 0.22 grams
SYMBOLS
MB1S 100 70 100
MB2S 200 140 200
MB4S 400 280 400 1.0
MB6S 600 420 600
MB8S 800 560 800
MB10S 1000 700 1000
UNITS VOLTS VOLTS VOLTS Amps
VRRM VRMS VDC IF(AV)
深圳理悠科技有限公司
MB1S THRU MB10S
MBS
.193(4.90) .177(4.50) .033(0.84) .022(0.56)

SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIERS Voltage Range - 100 to 1000 Volts Current - 1.0 Ampere FEATURES
TA, AMBIENT TEMPERATURE (°C)
1.2
1.4
1.6
VF, INSTANTANEOUS FORWARD VOLTAGE (V)
I FSM, PEAK FORWARD SURGE CURRENT (A)
Fig. 3 Maximum Peak Forward Surge Current (per leg) 35 30
.157(4.00) .142(3.60)
.276(7.0)
+
MAX
.102(2.60) .087(2.20) .014(0.35) .006(0.15)
.053(1.53) .037(0.95) .106(2.70) .090(2.30) .118(3.0) MAX .043(1.10) .028(0.70)
0
1
1.0
1
10 VR, REVERSE VOLTAGE (V)
100
NUMBER OF CYCLES AT 60 Hz
FIG.5 TYPICAL REVERSE CHRACTERISTICS
INVSTANTANEOUS REVERSE CURRENT (µA)
10 00
100
T J= 125 C
O