试题九

三层交换机与路由器间RIP动态路由协议的配置

三层交换机：

Switch>en

Switch#conf

Switch(config)#ip routing

Switch(config)#vlan 10

Switch(config-vlan)#exit

Switch(config)#int ra fa 0/10

Switch(config-if-range)#sw acc vlan 10

Switch(config-if-range)#no sh

Switch(config-if-range)#exit

Switch(config)#vlan 20

Switch(config-vlan)#exit

Switch(config)#int ra fa 0/20

Switch(config-if-range)#sw acc vlan 10

Switch(config-if-range)#exit

Switch(config)#int vlan 10

Switch(config-if)#ip add 192.168.10.1 255.255.255.0

Switch(config-if)#no sh

Switch(config-if)#exit

Switch(config)#int vlan 20

Switch(config-if)#ip add 192.168.20.1 255.255.255.0

Switch(config-if)#no sh

Switch(config)#router rip

Switch(config-router)#network 192.168.10.0

Switch(config-router)#network 192.168.20.0

路由器：

Router>en

Router#conf

Configuring from terminal, memory, or network [terminal]?

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#int f0/1

Router(config-if)#ip add 192.168.20.2 255.255.255.0

Router(config-if)#no sh

Router(config-if)#

%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up

Router(config-if)#exit

Router(config)#int f0/0

Router(config-if)#ip add 192.168.30.1 255.255.255.0

Router(config-if)#no sh

Router(config-if)#

%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up

Router(config-if)#exit

Router(config)#router rip

Router(config-router)#network 192.168.30.0

Router(config-router)#network 192.168.20.0

Router(config)#

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router#