8
6
4
3
3
3
3
3
6
6
- (at 120Hz)
105℃施加额定工作电压和最大允许纹波电流经下表规定时间，恢复到20℃后，产品性能应满足以下要求
The following specifications shall be satisfied when the capacitors are restored at 20℃ after subjected to DC
高温储存特性
1000 hours at 105℃ without voltage applied.
Shelf Life
Rated voltage
6.3 ~ 100V
160 ~ 450V
capacitance change
≦±20% of the initial value
≦±20% of the initial value
voltage with the rated ripple current is applied for the specified period of time at 105℃.
耐久性
Time for 6.3 ~ 100V
3000 hours
Endurance
Time for 160 ~450V
5000 hours
±20%(M)
(at 20℃,120Hz)
6.3 ~ 100V
160 ~ 450V
I≤0.03CV or 4μA,Which is greater application of rated Voltage
Time After 1minute After 5minutes
漏电流
after 1 minute。施加额定工作电压1分钟后读数，二者取大值。
CV>1000 I=0.04CV+100 I=0.02CV+25
Note: I=Max.leakage current (uA), C=Nominal capacitance(uF), V=Rated voltage(V)
(at 20℃)
Rated voltage(V)
6.3 10 16 25 35 50 63 100 160 ~ 250 400 450
使用温度范围
Category Temperature Range
-55 ~ +105℃(6.3 ~ 100V) -40 ~ +105℃(160 ~ 400V) -25 ~ +105℃(450V)
额定工作电压范围 Rated Voltage Range
6.3 ~ 450V
静电容量允许偏差 Capacitance Tolerance
0.30
0.50 0.70 0.20 0.40 0.60 0.20 0.30 0.40 0.25 0.35
0.68
0.80 0.88 0.66 0.76 0.84 0.60 0.65 0.75 0.61 0.66
0.91
1.00
0.94
1.00
0.97
1.00
0.90
1.00
0.93
1.00
0.96
D.F.(tanδ)
≦200% of the specified value
≦200% of the specified value
Leakage current
◆ 外形图Dimensions (mm)
L±α
15min.
5min.
≦The specified value
≦500% of the specified value
低温特性
电容器在120Hz下的阻抗比值，不应超过下表所列出的值
Low Temperature
Rated voltage(V)
6.3 10 16 25 35 50 63 100 160 ~ 250 400 450
Characteristics
Z(-25℃)/Z(+20℃)
4
3
2
2
2
2
2
2
3
5
6
(Max.Impedance Ratio) Z(-40℃)/Z(+20℃)
ΦD 5 6.3 8 10 13 16 18 P 2.0 2.5 3.5 5.0 5.0 7.5 8
Safety (ΦV8eunpt)
Vinyl sleeve
Rubber end seal
Φd±0.05 Tinned copper-ply wire
c P±0.5 D±0c.5
Φd 0.5 0.5 0.5 0.6 0.6 0.8 1
Kang Fusong group (Hong kong) Co.Ltd.
康富松铝电解电容封装规格
● Low impedance type ● For switching power supply ● RoHS Compliant ◆ 规格表 Specifications
项目Items
特性参数Characteristics
损耗角正切值tanδ
tanδ(Max.)
0.22 0.19 0.16 0.14 0.12 0.10 0.09 0.08 0.20 0.24 0.24
Dissipation Factor
标称容量超过1000uF,则每增加1000uF,损耗角正切值增加0.02.
When nominal capacitance exceeds 1000μF,add 0.02 to the value above for each 1000μF increase. (at 20℃,120Hz)
0.40
0.75
0.93
1.00
6.3 10
Φ5 (100μF), Φ6.3,Φ8
0.70
0.86
0.96
1.00
Φ10 ~ Φ18
0.85
0.95
0.98
1.00
16 ~ 35
50 63
100 160 ~ 450
Φ5 (~ 22μF)
Φ5 (33μF ~), Φ6.3,Φ8 Φ10 ~ Φ18 Φ5 (~ 3.3μF) Φ5 (4.7μF ~), Φ6.3,Φ8 Φ10 ~ Φ18 Φ5 (~ 1μF) Φ5 (2.2μF ~), Φ6.3,Φ8 Φ10 ~ Φ18 Φ10 Φ12.5 ~ Φ18
α
(L<20)1.5 (L≧20)2.0
◆ 纹波电流补正系数 Rated Ripple Current Coefficient
● 频率系数 Frequency Coefficient
Rated Voltage(V) Case code
Frequency(Hz) 120
1K
10K
100K
Φ5 (~ 47μF)
Hale Waihona Puke CV1分钟读数5分钟读数
Leakage Current
I≤0.01CV or 3μA,Which is greater application of rated Voltage after CV≦1000 I=0.1CV+40 I=0.03CV+15
2 minutes. 施加额定工作电压2分钟后读数，二者取大值。
1.00
0.88
1.00
0.90
1.00
0.93
1.00
0.88
1.00
0.89
1.00
Capacitance change
≦±20% of the initial value
D.F.(tanδ)
≦200% of the specified value
Leakage current
≦The specified value
105℃放置1000小时，恢复到20℃后，产品性能应满足以下要求
The following specifications shall be satisfied when the capacitors are restored at 20℃ after exposing them for