信道搜索的加载速率
CLR
FR TCH资源下限
HRL
SDCCH的最大平均占用时间 MAXHTS
TCH的最大平均占用时间 MAXHTT
最大下行TBF使用数量
MNDL
最大上行TBF使用数量
MNUL
高TCH干扰监控的测量时段 PRDHIF
SDCCH平均占用时间监控的 测量时段
PRDHMS
无事务的BTS监控的测量时 段
BCSU load threshold BSC call number C/I target AMR FR C/I target AMR HR C/I target FR
DCS macrocell threshold
DCS microcell threshold delay of HO and PC for emergency calls disable external DR disable internal HO enable call re-establishment on FACCH
HRC
AMR HR hysteresis 1 AMR HR hysteresis 2 AMR HR hysteresis 3 AMR HR start mode AMR HR threshold 1 AMR HR threshold 2
priority level QC drop action trigger threshold QC NCCR action trigger threshold QC QoS renegotiation action trigger threshold QC reallocation action trigger threshold
SDCCH可用性告警界限
参数简 称 ALFRT ALHRT
ALSDC
alarm threshold for number of channel seizures
信道占用数量告警门限 CS
alarm threshold for number of channel seizure Requests
信道占用请求数量告警门限 CSR
全速率信道所需C/I值
SBF
半速率信道所需C/I值
SBH
BTS监控的起始时刻
SMBNT
切换中的TCH
HRI
TCH概率1 TCH概率2
TCP1 TCP2
TCH概率3
TCP3
threshold for high TCH interference level
TRHO guard time
upper limit for FR TCH resources
alarm threshold for SDCCH congestion
alarm threshold for SDCCH failure rate
alarm threshold for TCH congestion
SDCCH拥塞告警门限
CNGS
SDCCH故障率告警门限
SCHFR
TCH拥塞告警门限
CNGT
BCCH TRX关闭定时器
BTIM
BCF标识
比特率 BTS电池备份过程
BCF identi ficati on
BR
BBU
D-channel link set name
D信道链路集名称
DNAME
D-channel link set number
D信道链路集编号
DNBR
external input number
AMH负载下限
ALT
目标小区的AMH最大负载 AML
AMH负载上限
AUT
切换中AMR的配置
CNGT
坏质量极限
BQL
BCSU负载门限
BCSUL
BSC呼叫号码 AMR全速率载干比目标
BCN CIAF
AMR半速率载干比目标
CIAH
全速率载干比目标
CNGT
DCS宏蜂窝门限
DMAC
DCS微蜂窝门限
DMIC
紧急呼叫中切换和功率控制 延迟
好质量极限 GPRS宏蜂窝门限
GMAC
GSM微蜂窝门限
GMIC
DL干扰下的切换优先级 HDL
UL干扰下的切换优先级 HUL
初始AMR信道速率
IAC
LAPD负载门限
LAPDL
load rate for channel search
lower limit for FR TCH resources
AMR FR hysteresis 1
下行最小C/I值估算
ADCE
上行最小C/I值估算 自适应LA算法 AMH负载下限 AMH负载上限
AUCE ALA ALT AUT
AMR全速率编码模式集
FRC
AMR全速率滞后1
FRH1
AMR FR hysteresis 2
AMR全速率滞后2
FRH2
AMR FR hysteresis 3 AMR FR start mode
RX antenna supervision period
RX level balance
RX level based TCH access
service area penalty time
TCH最小保持时间 MS距离触发的行为
MINHTT DISB
NACC 开启
NACC
可忽略的码变换器故障的数 量
maximum mean holding time for SDCCHs
maximum mean holding time for TCHs
maximum number of DL TBF
maximum number of UL TBF measurement period for high TCH interference Supervision
MSSCF MSSCS VDLS
add BCF to chain administrative state
添加BCF到链路
ADD
管理状态
admini strati ve state
autoconfigure
自动配置
AC
BCCH TRX shutdown timer
BCF identification bit rate BTS battery backup procedure
ITCF
首选小区的数量
NPC
优先级
PR
质量控制下的掉话触发门限 QCATD
质量控制下NCCR触发门限 QCATN
质量控制下服务等级重新定 义触发门限
QCATQ
质量控制下信道重新分配触 发门限
QCATR
RX天线监控时段
RXANT
RX电平平衡
RXBAL
基于接收电平判别的TCH接 入
RXTA
服务区惩罚时间
upper limit of MS speed class 1 upper limit of MS speed class 2
variable DL step size
高TCH干扰电平的门限 TRHO保护时间
HIFLVL TGT
全速率信道资源上限
HRU
MS速度类别1的上限 MS速度类别2的上限 变量DL的步长大小
measurement period for SDCCH mean holding time supervision
measurement period for supervision of BTS with no transactions measurement period for supervision of channel failure rate measurement period for supervision of congestion in BTS measurement period for TCH mean holding time Supervision
PRDBNT
信道故障率监控的测量时段 PRDCFR
BTS中拥塞监控的测量时段 PRDCNG
TCH平均占用时间监控的测 量时段
PRDMHT
minimum mean holding time for TCHs
MS distance behaviour
NACC enabled
number of ignored transcoder failures number of preferred cells
SAPT
signal quality limit 1
信号质量限制1
SQL1
signal quality limit 2
信号质量极限2
SQL2
slow AMR LA enabled
soft blocking C/I 14.4 soft blocking C/I AMR FR soft blocking C/I AMR HR
DEC
外部直接重试禁止
DEXDR
内部切换禁止
DINHO
FACCH呼叫重建立允许
ERF
enable emergency call on FACCH enable ordinary calls on FACCH FEP in PC HO use
free TSL for CS downgrade
FACCH紧急呼叫允许
无
SAL
14.4Kbit/s编码所需C/I值 SBCI
全速率AMR所需C/I值
SBAF
半速率AMR所需C/I值
SBAH
soft blocking C/I FR
soft blocking C/I HR starting moment for supervision of BTS TCH in handover TCH probability 1 TCH probability 2 TCH probability 3