The Miller DeltaForce T emporary Horizontal Lifeline adds a new dimension
to fall protection versatility.
• Continuous fall protection for the length of the lifeline
• Ideal for applications where an overhead anchorage does not exist
• Systems available for steel and concrete installation • Available in single-span systems (no intermediate
stanchions) up to 60 feet and multiple-span
systems up to 300 feet
• Modular design allows you to customize your
own system
• Intermediate stanchions permit worker to
pass without disconnecting from the
lifeline--100% tie-off
• Lightweight stanchions (approx.
40 lbs. each) for easy 1-person
installation and handling--no tools
required for stanchion installation
• Adjustable beam clamps fi t a wide range
of beam fl anges as well as the bracket adapter
for concrete installation
Applications
Steel Building Erection Bridge Work Pipe Rack Erection Maintenance Leading Edge Work
Concrete Work
May also be used as a
Perimeter Warning Line
in Controlled Access Zones
• Low-profi le extension bar
reduces trip hazards
• Stanchions offset for easier worker
maneuverability
•Unique engineering design for I-beam installation
allows worker to immediately attach to the lifeline
eliminating fall hazards
(Competitive units require worker to walk out on the beam
or concrete several feet before attaching)
• 48-inch stanchion height reduces extended free fall distance
• Includes the • Accommodates 2 workers per span with a maximum of 5 workers per system
• Meets OSHA and ANSI requirements
Intermediate stanchion head permits 100% tie-off I-Beam Installation
Now the same DeltaForce
System used for I-beam
applications may be
adapted for installation
to concrete!
• Attaches to rebar
• Attaches to single fl ared coil inserts (Dayton/Richmond B-18 3/4” x 6”)
In addition to the system itself, the following
attachments are required:
• Two tie-back anchor brackets with an additional
shock absorber for use at each end of the lifeline system
• One bracket adapter for each intermediate and end stanchion Additional DeltaForce System Attachments Required for Concrete Applications Model Number Description
DFPCA Two tie-back anchor brackets and shock absorber
(One DFPCA kit required per system)
DFPCB One bracket adapter required for each stanchion
(Number of DFPCB bracket adapters required
based on total number of stanchions in system, including end and intermediate stanchions)
NOTE: DeltaForce System components may be ordered separately.
Contact Miller Customer Service at 800-873-5242. Ordering Information DeltaForce Systems
(Includes two end stanchions, 3/8” dia. galvanized steel wire rope lifeline with Xtreme inline shock absorber, turnbuckle, combination clamp and thimble, anchor shackle, and wire rope clip)
Model Number Model Number
(For beam fl anges (For beam fl anges
4” to 18” wide 6” to 24” wide
up to 1.5” thick) up to 2.5” thick)Length Description
DFA18-30 DFA24-30 30’ Single-span DeltaForce system;
accommodates 2 workers
DFA18-60 DFA24-60 60’ Single-span DeltaForce system;
accommodates 2 workers
DFB18-100 DFB24-100 100’ Multiple-span DeltaForce system
w/1 intermediate support stanchion;
accommodates 4 workers
DFB18-200 DFB24-200 200’ Multiple-span DeltaForce system
w/3 intermediate support stanchions; ;
accommodates 5 workers
DFB18-300 DFB24-300 300’ Multiple-span DeltaForce system
w/5 intermediate support stanchions; accommodates 5 workers Concrete Installation。