当前位置:文档之家› 双频四端口电调天线技术规范书

双频四端口电调天线技术规范书

产品说明书
装箱清单 PACKING LIST
序 号 1 2 3 4 5 6 品 双频四端口电调天线 安装说明 产品合格证 天线电气指标说明书 安装支架 装箱清单 名 数 量 1付
安装说明
Installation instruction
步骤1:地面准备工作 step 1:Preparation on the ground 如图1,图2所示,把上支架安装在天线上端,下支架安装在天线的下端,并照图4要求扭力拧紧螺母. As shown in figure 1 and 2 upper bracket is fixed at top of the antenna,lower bracket is fixed at bottom of the antenna,and nuts are tightened. 上支架 upper bracket
bottom of antenna
1张 1份 1套 1份
ቤተ መጻሕፍቲ ባይዱ
top of antenna
1份
下支架 lower bracket
图1 ( figure 1 ) 步骤2: 安装天线 step 2: Mounting antenna 如图3所示,合拢可调倾角支架,将调节螺栓稍微 拧紧,把天线安装在抱杆上,并从上支架开始拧 紧,然后拧紧下支架,抱杆直径为 Φ55∽Φ114mm As shown in figure 3 ,folding adjustablo lilt angle bracket and slightly tighten setting bolt then mounting the antenna at mast firstly fix lower bracket then fix upper bracket mast Diamlter:Φ55∽Φ114mm
将刻度线对准调节螺栓中心 Align scale line to the center of setting bolt
天线电气技术指标
电气性能 频率范围 增益 极化形式 输入阻抗 驻波比 端口隔离度 系统隔离度 水平面波瓣宽度 垂直面波瓣宽度 下倾角范围 第一上旁瓣抑制 前后比 0° 交叉极化 鉴别率 ±60°交叉极化 鉴别率 三阶互调 功率容量 接口形式 机械性能 尺寸 重量 天线罩材料 天线罩颜色 接头位置 机械下倾 抱杆直径 抗风强度 工作温度 雷电保护 Electrical Frequency (MHz) Gain (dBi) Polarization Input Impedance VSWR Isolation Between Inputs(dB) Isolation,Intersys tem, dB Horizontal beam width, -3dB Vertical beam width, -3dB Electrical down tilt(°) First Upper de-lobe Suppression (dB) Front-to-back ratio (dB) 0 ° Cross-Polar Discrimination 60 ° Cross-Polar Discrimination IM3 (2×43dBm) Max Input Power Connector Mechanical Specifications Dimensions Weight Radome Material Radome Colour Connector Position Mechanical Tilt Mounting Hardware Survival wind speed Operating Temperature Lighting otection 1530×280×149 mm 17Kg Fiberglass Gray Bottom 0°~15° φ55-φ114mm 60m/s -40°C~+70°C DC grounded 1710~2180 MHz 1710~2180 MHz Specifications 698~806 13.4 806~896 1710~1880 1850~1990 1920~2180 16.6 ±45° 50Ω <1.5 ≥28 35 33 40 40 40
产品合格证 CERTIFICATE OF QUALITY
产品名称 产品编号 产品型号 序列号 数量 生产日期 检验 检验员 双频四端口电调天线
刻盘示图 SCALE DISC VIEW
连接螺栓 linking bolt 抱杆 Mast 调节螺栓 setting bole 连接螺栓 linking bolt 图4 ( figure 4 ) 规格(Size) M12-1.75 推荐力矩 56 N.m M10-1.5 35 N.m M8-1.25 17 N.m
图2 ( figure 2 ) 步骤3: 调节天线下倾角 step 3: adjust antenna downtilt 如图4所示,调节机械下倾角至正确位置,将 图3所示调节螺栓和连接螺栓拧紧,安装完毕. As shown in figure 4,adjusting mechanical downtilt of the correct angle then tightened setting bole and linking bolt,thus installation is finished.
7/16 7/16 7/16 7/16 698-896MHz +45 1710-2180MHz +45
电调驱动方式:内置 RET
端口示意图
Range
14.6
17.6
17.1
698-896MHz -45 1710-2180MHz -45
65°±7° 65°±9° 65°±6.5° 6 5°±6.5° 65°±6.5° 19° 0~15 16 18 15 9 17° 0~15 16 21 15 6 7.5° 0~8 15 28 18 10 ≤-150dBc 300W 4×7/16 DIN Female 7° 0~8 16 29 19 10 ≤-150dBc 698~896 MHz 698~896 MHz 6.6° 0~8 15 27 20 6 方 水平面方向图 Horizontal pattern 向 图 垂直面方向图 Vertical pattern
相关主题