列入表中
are listed in
is presented in
are summarized in
is shown in
As we know, the sample failure time of step-stress test in Table II has to be converted into the failure time at constant-stress.
The physical parameters of the flue gas are given in Table.
如图所示
The specific coupling relationship is illustrated in Fig. （示意图、流程图）
can be found from Fig.
as shown in
is plotted in Fig. 2,
Fig. 5a and b respectively show
Fig. 6 gives dynamic curves of
Fig. 7 displays the characteristic curves of the maximum amplitude of the plate versus the magnitude of the applied magnetic field with different impulse parameter time
The detailed iterative procedures are displayed in Fig.
Fig. 8 plots the characteristic curves of the critical value varying with the length–thickness ratio of the plate for different electric conductivity
10. the numerical results shown in Fig. 7 exhibit that
1 From Fig. 7, it will be found that
1 It can be found, from Fig. 5a, that
1 , shown in Fig. 5b,
1 It is found from Fig. 3 that
1 Similar to Fig. 7, Fig.9 also exhibits that
1 Fig. 8 exhibits that
1 The curves given in Figs. 8 and
1 Fig.5 compares present overall efficiency with the result got by Huang Z. et al. (2007). It is very clear that the calculated overall efficiency shows a very good agreement with the one
1 Comparing Fig. 6 (a) and (b),
20. As shown in Fig. 6 (b), (c) and (d),
2 Two effects of applied magnetic field on PM5 collection efficiency can be further identified in Fig. 10.
2 Fig. 6 depicts the vipation divergence curves of maximum displacement and
Mises stress under three conditions with UFSI considered, and it is clear that:
2 Fig. 6 depicts the vipation divergence curves of maximum displacement and
Mises stress under three conditions with UFSI considered, and it is not difficult to find that
2 the maximum Mises stress of the blade also increases with time and divergence
phenomenon becomes visible (see Fig. 6 (b), (d) and (f)).
从……看出
It can be seen that
It is very clear that the calculated overall efficiency shows a very
good agreement with the one
It can be seen in Fig. 9 that
Furthermore, it is identified that
Fig. 11 presents the PM5 overall efficiency under the same conditions as used in Fig. 10.
which is consistent with the second point drawn from Fig. 10.
Further, from top four curves in Fig. 12, it can be seen, at a given particle size that (see Figs. 10 and 11)
公式描述
combining (16) and Fig. 2, the following transition formula is obtained:
can be written as
can be rewritten as。