Autoliv:oknokNARemarks:Checking list before trial 试模前检查清单Danger of injure伤害的危险物Sharp edges尖锐的边缘Whether there are no damage in equipment是否没有设备损伤Parting line surface fit well 分型面贴合良好Smooth texture of cavity,crackfree 型腔光滑、无裂缝Surface roughness 光洁度要求The circuit of water system is correct without leaking 冷却系统进出回路正确Check the quality of polishing on all ribs、bosses 检查所有筋、褡子的抛光质量Fluent action of the ejection pin顶出系统动作流畅Complete components零件是否装齐Whether the size fit request尺寸是否符合要求Whether the components match with the drawing(eg.radius of the sprue bush、locationring、mold plate、all kinds of connectors, etc)是否零件尺寸与图纸相匹配(如浇口套R、定位圈、模板、各类接头等)Label the die height and weight on the mold 将模重标识于模具上Parting line surface fit well 模具型面质量是否达到要求The pouring intake of mould is ok(Size,Position) 模具的浇注系统是否合理(尺寸,位置)The type of water tie-in answer our need 水接头型号符合要求，无干涉Position and size of the annectent plate or screw 安全连接板的尺寸、安装合适Whether the position of exhaust is good 模具排气口位置是否合理It is firm and safe when suspensory 起吊平稳、安全、无干涉Nameplate of mould 模具铭牌Stability of mould when it is moving on the mould carrier 模具开合模平稳Checking list for the tool after trial 模具试模后检查清单:Whether lt can move smoothly 是否能平稳动作Whether it have no negative effect to the other equipment 对其他设备是否无影响No air bubble,No drape,No mark by pulling,No distortion是否无气泡、无褶皱、无拉伤和变形Whether the flash fit request飞边厚度是否符合要求Whether the mushion is easy to take out 蘑菇头是否容易取出Achieve the require of product size 产品尺寸达到要求The texture of products is clear 产品纹理是否清晰Reaction time 模具发泡周期（ ）秒Whether it is easy to extraction products 产品取件是否方便Documentation 文件:Assembly drawing (Paper)组装图纸Assembly drawing (CAD)组装图纸Single part drawing (CAD)单个零件图纸BOM mechanic 机械设备清单Supplier index 供应商一览Spare part listing 备件清单Wearing part listing 易损件清单Maintenace instructions 维修手册Adjustment instructions 调整手册Operation instructions 操作指导书Environment influence evaluation环境影响评估:Risk assessment风险评估environment aspect 环境因素SupplierMould & Frock approval 模具工装验收单Project:Date:Autoliv:Pre-Finalapproval:Supplier:SignitureLocation:
Druck: 2017/4/6
423199493.xls / 模具工装验收单
1/2