When the operating temperature exceeds 65C (prEN563), even short-term surface contact may cause skin burn
All original guards of the screen must be appropriately fastened while the screen is running - do not remove them during operation!
Slide 2 F_material3_machine bInstallation and Maintenance Manual
Safety instructions
Mounting of Equipment
the supplier of the screen is only responsible for the assembly of the screen prior to delivery during the mounting, the fastening of the washer installed at the end of the shaft of the electric motor must be taken into account!
Before maintenance, stop the drive motor and disconnect it from the electrical supply
Before opening the cover of the screen: make sure that the screen is de pressurized make sure that no liquid or stock can flow into the screen
Fiber Preparation Systems
Slide 3 F_material3_machine book.ppt 10/2002 KN/Kotka
Operation, Installation and Maintenance Manual
Safety instructions
During Operation
Check the maximum feed pressure of the screen from the dimensional drawing appended to the instructions
Do not use the screen at a temperature higher than notified while the order was being made
Operation, Installation and Maintenance Manual
delivered with each machine delivery
includes also assembly and dimension drawings and part lists
Fiber Preparation Systems
During Operation
Check the maximum feed pressure of the screen from the dimensional drawing appended to the instructions Do not use the screen at a temperature higher than notified while the order was being made When the operating temperature exceeds 65C (prEN563), even short-term surface contact may cause skin burn All original guards of the screen must be appropriately fastened while the screen is running - do not remove them during operation! All maintenance of the screen and its drive motor is forbidden during operation
The screen can be started after maintenance only after: the cover of the screen has been closed all original guards have been installed properly
All maintenance of the screen and its drive motor is forbidden during operation, except:
lubrication of bearings adjusting sealing water flow and pressure de-aeration of the screen
Fiber Preparation Systems
Slide 4 F_material3_machine book.ppt 10/2002 KN/Kotka
Operation, Installation and Maintenance Manual
During Operation
Use appropriate hoisting equipment when lifting the screen
Slide 1 F_material3_machine book.ppt 10/2002 KN/Kotka
Operation, Installation and Maintenance Manual
Safety instructions - Lifting
aa
a max = 30?
Fiber Preparation Systems